The Easiest Way to Build a Mirror Frame
If you have a mirror and it either needs a frame or needs a new frame you can build one economy than it may cost to buy one. You will need some tools but it doesn't take very much skill to properly build a frame for your mirror. You will need a saw, preferably a miter saw but a suitable hand saw will be sufficient. You will also need wood glue, a hammer and small framing nails.
The first step would be to development the base which will but the main withhold retention your mirror. Depending on the size of your mirror you may need distinct size wood to build your support. To build a 24 inch by 24 inch mirror I would use a ½-1 inch by 2-3 inch piece of wood. After you part and cut the pieces of wood for your withhold you should lay it out how it will be constructed. Lay your mirror on top of the wood. Your mirror should lay about halfway into the support. Trace the mirror and now you know where to cut your grooves. You need to cut into the wood about as thick as the glass that way it can positively sit into your support. All four sides should have the same size groove and now you can put them together using framing nails and wood glue.
Framing Nails Degree
Now that you have your withhold made you can buy some modeling at your local hardware store. This will be located on top of your mirror and frame to give it a finished look. You can buy stain and stain your modeling and withhold if you do not like the general wood color. If you determine to stain it, be sure to buy a clear coat to desist the stain job. When cutting and measuring your modeling you need to cut at 45 degree angles, which is why a miter saw it adored but it is inherent with a hand saw. Now that your pieces of modeling are cut and stained, you can assemble them. Use wood glue to associate them and use masking tape to hold them together while the glue dries. Now that your modeling is assembled and glue you can lay it on top of your withhold and mirror. Once you confirm the sizes are matching up you can glue the model to the support. Use masking tape to hold it until the glue dries. You should also take framing nails from behind the withhold and hammer them through the withhold wood into the modeling. Once you are done with the nailing and the glue has dried you just need to frame wiring to run in the back of your frame and it is ready to hang on your wall.
It will take some time if you are not customary with wood working but if you have patience you will originate a gorgeous mirror frame. You can save money and be proud of what you have created.
The Easiest Way to Build a Mirror Frame
No comments:
Post a Comment